Laserfiche WebLink
<br />'--' <br /> <br />agreement made that the Board would not rezone anything residential <br />until changes are made in the Master Plan. A motion was made <br />by Charles McGuire to table Swinney Brothers request at this time. <br />A second was made by Shirley Welker. Motion passed 5 - O. <br />Roger Caperton came before the Board regarding the plans <br />for extending Bridge Street with sewer and water utilities east <br />to Landersdale Road. After discussion, Joel Beebe pointed out <br />that this was approved with the original plans but asked for a <br />motion to reapprove. A motion to reapprove was made by Bill Abbott. <br />A second was made by Charles McGuire. Motion passed 5 - O. <br />Bill Abbott told Tim and the Board that he had been contacted <br />by Deerwester regarding the development of one of the roads in <br />their subdivision even though they did not have final plat approval. <br />Bill said that he told him he might want to contact Tim to see <br />what the legal ramifications might be if they did so and see if- <br />Joe would inspect the work. <br />Joel then reported that at the Special Meeting it was <br />determined that changes in the zoning specifications would be <br />within the R classification. We would keep R1 and under that would <br />be sub-titles RIA, B, C rather than make completely new ones <br />and that way the map would remain the same. Major changes would <br />be 1) minimum lot size not on sewer would be increased from <br />35,000 to 43,560 sq. ft. and septic system still subject to <br />approval from the State Board of Health. Rl Zoning classification <br />would be broken down in the following manner: RIA minimum lot <br />size 24,000 sq. ft. and the size of the home 1,800 sq. ft. minimum. <br />Minimum of 1,350 on the ground floor and this is defined as low <br />density. RIB is medium low density residential with minimum of <br />20,000 sq. ft. lot size, 1,600 sq. ft. home with minimum of <br />1,200 sq. ft. on ground floor. R1C medium high density with <br />16,000 sq. ft. minimum lot size, 1,400 sq. ft. minimum home with <br />a minimum of 1,150 sq. ft. on ground floor area. RID would be <br />the high density residential with 12,000 sq. ft. minimum lot size, <br />1,000 sq. ft. minimum home with a minimum of 825 sq. ft. on <br /> <br />---' <br /> <br />- 2 - <br />